Yukon Denali 2WD V8-6.0L Hybrid (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Position the knock sensor (718) to the engine block and install the knock sensor bolt (739). Tighten the bolt to 25 Nm (18 lb ft).
2. Connect the engine wiring harness electrical connector (3) to knock sensor.
3. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
4. If removed, install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side (See: Body and
Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Right Side).
