Yukon Denali 2WD V8-6.0L Hybrid (2010)
Note: Only remove the 2 bolts indicated in the graphic. Under NO circumstances are the power steering assist motor housing bolts to be removed
or loosened. If two or more of these bolts are removed or loosened the steering gear will need to be replaced because the steering gear housing to
gear lash will be out of specification.
12. Remove the power steering assist motor bolts (1).
Note: DO NOT remove the power steering assist motor electrical harness from the power steering assist motor. They are serviced as a unit only.
13. Remove the power steering assist motor and electrical harness (2).
14. Remove and ensure the power steering assist motor seal (3) is kept protected while out of the vehicle as it will be needed for reinstallation.
Installation Procedure
1. Install any new wiring harness retainers as needed.
Note: It may be necessary to rotate the front tire and wheel assembly while installing the power steering assist motor to in order for it to mesh
with the steering gear properly.
