Yukon Denali 2WD V8-6.0L Hybrid (2010)
Note: Install the rear wheel bearing adjuster nut by hand.
16. Using the J 2222-C - wrench, adjust the rear wheel bearings. Refer to Wheel Bearing Adjustment (See: Service and Repair/Procedures/Wheel
Bearing Adjustment)
17. Install the rear axle shaft. Refer to Rear Axle Shaft and/or Gasket Replacement (See: Drive Axles, Bearings and Joints/Seals and Gaskets/Service
and Repair/Rear Axle Shaft and/or Gasket Replacement).
18. Install the brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement (1500 Series) (See: Brakes and Traction Control/Disc Brake
System/Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper Bracket Replacement (1500 Series))Rear Brake Caliper
Bracket Replacement (2500 Series) (See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Rear Brake Caliper Bracket Replacement (2500 Series)).
19. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
20. Inspect and add axle lubricant to the axle housing, if necessary. Refer to Rear Axle Lubricant Level Inspection (8.6, 9.5 LD Axle) (See: Fluid -
Differential/Service and Repair/Procedures/Rear Axle Lubricant Level Inspection (8.6, 9.5 LD Axle))Rear Axle Lubricant Level Inspection (10.5
Inch Axle) (See: Fluid - Differential/Service and Repair/Procedures/Rear Axle Lubricant Level Inspection (10.5 Inch Axle)).
21. Remove the supports and lower the vehicle.