Yukon Denali 2WD V8-6.0L Hybrid (2010)
Quarter Window Glass: Service and Repair
Quarter Window Replacement
Special Tools
*
J 24402-A Glass Sealant Remover (Cold Knife)
*
J 39032 Stationary Glass Removal Tool
*
Use a urethane adhesive systems which meet GM Specification GM 3651G:
Removal Procedure
Warning: Refer to Glass and Sheet Metal Handling Warning (See: Body and Frame/Service Precautions/Technician Safety
Information/Glass and Sheet Metal Handling Warning).
Warning: Refer to Cracked Window Warning (See: Service Precautions/Cracked Window Warning).
Note: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior
trim.
1. Open the liftgate.
2. Remove the right or left side rear applique. Refer to Quarter Panel Upper Applique Replacement (GMC Yukon Hybrid 2 Mode) ()Quarter Panel
Upper Applique Replacement (Tahoe) ().
3. Remove the rear door upper garnish trim. Refer to Rear Door Upper Garnish Molding Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair/Rear Door Upper Garnish Molding Replacement).
4. Disconnect the electrical connector from the quarter window.
Warning
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
5. Cover the following parts to protect from broken glass:
1. The upper dash pad
2. The defroster outlets and A/C outlets
3. The seats and the carpeting
Note: Keep the cutting edge of the tool against the quarter window from inside the vehicle. This will allow the urethane adhesive to be separated
from the window.
6. Use J-24402-A - Glass Sealant Cold Knife Remover, J-39032 - Stationary Glass Removal Tool, or equivalent in order to remove the quarter
window.
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.