Yukon Denali 4WD V8-6.0L Hybrid (2011)
7. Compress the caliper piston.
1. Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the piston is pushed completely into the caliper bore.
3. Remove the C-clamp from the caliper.
Note: Cap or plug the brake pipe to prevent brake fluid leakage and contamination of the brake system.
8. Remove the brake hose to caliper bolt. Position the brake hose to the side.
Note:
*
Ensure that the copper gaskets are not attached to the brake caliper or the brake hose.
*
DO NOT re-use the copper gaskets, replace with NEW.
9. Remove and discard the 2 copper brake hose gaskets.
Note:
