Yukon Denali 4WD V8-6.0L Hybrid (2011)
8. Install the brake caliper bracket bolts and tighten to 200 Nm (148 lb ft).
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
10. With the engine OFF gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds then repeat steps 13-14 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
13. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling See:
Hydraulic System/Brake Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling.
14. If the brake rotor was refinished or replaced, burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing See: Brake Pad/Service
and Repair/Procedures.
