Yukon Denali 4WD V8-6.0L Hybrid (2011)
1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers See: Specifications/Adhesives,
Fluids, Lubricants, and Sealers.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Using J 41712 or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten the sensor to 35 Nm (26 lb ft).
3. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 Nm (26 lb ft).
4. Install the intake manifold. Refer to Intake Manifold Replacement See: Intake Manifold/Service and Repair/Intake Manifold Replacement.
