Yukon Denali 4WD V8-6.0L Hybrid (2011)
14. Install EN-48853 to the front cover.
15. Install the crankshaft balancer bolt until snug. Do not overtighten.
1. Tighten the oil pan to front cover bolts to 25 Nm (18 lb ft).
2. Tighten the engine front cover bolts to 25 Nm (18 lb ft).
16. Remove the tools.
17. Position the CMP sensor.
18. Connect the engine harness electrical connector (2) to the CMP sensor wire harness electrical connector.
19. Connect the camshaft position sensor wire harness electrical connector (1) to the CMP actuator magnet.
20. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement See: Seals and Gaskets/Front Crankshaft Seal/Service
and Repair.
21. Install the water pump. Refer to Water Pump Replacement See: Water Pump/Service and Repair.