Yukon Denali 4WD V8-6.0L Hybrid (2011)
Knock Sensor: Service and Repair
Knock Sensor 2 Replacement
Knock Sensor 2 Replacement
Removal Procedure
1. If equipped with 4WD, remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side See: Body and
Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Right Side.
2. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
3. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (3) from knock sensor.
4. Remove the knock sensor bolt (739) and knock sensor (718).
Installation Procedure
