Yukon Denali 4WD V8-6.0L Hybrid (2011)
4. Tighten the steering linkage inner tie rod using wrench CH-49009 .
Tighten the steering linkage inner tie rod to 145 Nm (107 lb ft).
5. Align the new steering linkage inner tie rod washer (1) to the flats on the steering linkage inner tie rod and bend the tabs over the flats.
Note: The appropriate grease must be applied to the small end of the steering gear boot before installation.
6. Install the steering gear boot. Refer to Steering Gear Boot Replacement .
