Yukon Denali 4WD V8-6.0L Hybrid (2011)
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Special Tools
*
J 2222-C - Wheel Bearing Nut Wrench
*
J 8092 - Universal Driver Handle - 3/4 x 10 inch
*
J 24426 - Outer Wheel Bearing Race Installer
*
J 24427 - Inner Wheel Bearing Race Installer
*
J 44419 - Hub Bearing Installer
*
J 44420 - Differential Bearing Installer
Removal Procedure
Note:
*
The wheel speed sensor ring is NOT serviced separately. The hub and wheel speed senor ring are serviced as an assembly.
*
The wheel hub seal must be replaced anytime the wheel hub assembly is removed from the axle housing.
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
Note: In the following service procedure, it is not necessary to remove the brake caliper from the bracket.
3. Remove the brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
4. Remove the axle shaft. Refer to Rear Axle Shaft and/or Gasket Replacement See: Drive Axles, Bearings and Joints/Seals and Gaskets/Service
and Repair/Rear Axle Shaft and/or Gasket Replacement.
5. Remove the axle nut retaining ring.
