Yukon Denali 4WD V8-6.0L Hybrid (2011)
1. Using the J 45756 , install a NEW front output shaft seal.
2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Rear Propeller Shaft Replacement.
3. Check the fluid level. Add fluid, if necessary.
4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement See: Service and Repair/Removal and
Replacement/Transfer Case Shield Replacement.
5. Lower the vehicle.
