Yukon Denali AWD V8-6.2L (2007)
Brake Pad: Service and Repair
Replacement - Rear
Rear Disc Brake Pads Replacement (1500 Series)
Rear Disc Brake Pads Replacement (1500 Series)
Caution: Refer to Brake Dust Caution.
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the fluid level is midway between the maximum-full point and the minimum allowable level, no fluid needs to be removed from the reservoir
before proceeding.
3. If the fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove fluid to the midway point
before proceeding.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Remove the tire and wheel assembly.
6. Compress the brake caliper piston.
1. Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the piston is pushed completely into the caliper bore.
3. Remove the C-clamp from the caliper.
