Yukon Denali AWD V8-6.2L (2007)
2. NOTE: Refer to Fastener Notice.
Install the upper insulator retainers and the insulator retainer bolts.
Tighten the bolts to 2.4 N.m (21 lb in).
3. Connect the evaporator tube to the condenser using new sealing washers.
4. Install the evaporator tube nut to the condenser.
Tighten the nut to 16 N.m (12 lb ft).
5. Connect the compressor discharge hose to the condenser using new sealing washers.
6. Install the compressor discharge hose nut to the condenser.
Tighten the nut to 16 N.m (12 lb ft).
7. Install the lower bolts to the hood latch support bracket.
Tighten the bolts to 9 N.m (80 lb in).