Yukon Denali AWD V8-6.2L (2007)
19. Reinstall the harness connectors (1) to the MSM.
20. Reinstall the seat to the vehicle.
Heated and Cooled Seats (RPO KB6)
Follow the steps below to correct the concern with the heated and cooled seats.
1. Inspect the ventilation heating and cooling module for a concern with the TED. Refer to Seat Heating and Cooling, Diagnostic Information and
Procedures in SI.
Note
If the heated and cooled seat function is inoperative, but the heat switch indicators are On, the MSM is functioning properly and the concern is
with the TED.
2. If the TED is found to be the concern, replace the seat cushion or seat back ventilation heating and cooling module. Refer to Driver or Passenger
Seat Back Ventilation Heating and Cooling Blower Replacement or Driver or Passenger Seat Cushion Ventilation Heating and Cooling Blower
Replacement in SI. If the TED is not the concern, follow normal diagnostics and repair in SI.
*We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources.
Parts Information
Warranty Information
Use the appropriate Labor Operation based on the repair completed.
Heated Seats (RPO AN3, KA1)
For vehicles repaired under warranty, use:
Heated and Cooled Seats (RPO KB6)
