Yukon Denali AWD V8-6.2L (2007)
position of the ignition switch during the programming procedure, unless instructed to do so.
Make certain all tools connections are secure, including the following components and circuits:
^
The RS-232 communication cable port
^
The connection at the data link connector (DLC)
^
The voltage supply circuits
DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming failure or
control module damage may occur.
DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections
are secure and the TIS terminal operating software is up to date.
Tech 2 Pass-Thru Method for the Body Control Module (BCM)
1.
Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Use an additional jump
battery if necessary.
^
If the vehicle will not start, test and charge the battery. Refer to SI for battery testing and charging information, if required.
^
If the battery will not hold a charge, replace the battery/Do NOT replace the battery unless it can't be charged or a leak and/or physical damage
is present.
2.
Connect the Tech 2 to the vehicle and the TIS terminal.
3.
Turn the ignition to the ON position with the engine OFF.
4.
After all warning chimes inside the vehicle have stopped, turn on the Tech 2.
5.
On the TIS terminal go into SPS Programming.
6.
Select Pass Thru programming.
7.
Follow instruction on the TIS terminal. When you get to the Supported Controllers screen.
7.1.
Scroll down in the top box and select BCM (Body Control Module).
7.2.
In the lower box select Normal.
7.3.
Select Next.
Important:
Vehicles without the Driver Information Center (DIC) and power door locks/windows will have two calibrations from which to choose. A
selection is required before you can select NEXT. Select calibration 25814828. Do not select calibration 25788372.
8.
Select NEXT when the calibrations screen displays.
9.
Follow on-screen prompts until programming is completed.
10.
When programming is complete.
10.1. Turn off Tech 2.
10.2. Turn the ignition switch to the OFF position.
11.
Wait 30 seconds.
12.
Turn the ignition switch to the ON position with engine OFF.
13.
Turn on the Tech2.
14.
Go into diagnostics and check for DTC codes.
