Yukon Denali AWD V8-6.2L (2007)
11. Install the steering wheel control switch (3) into the new cover (1) with the screw fasteners (2).
12. Tighten the steering wheel control switch assembly screws.
Tighten
Tighten the switch assembly screws to 1 Nm (9 lb in).
13. Install the steering wheel lower cover assembly into the steering wheel shroud and seat the retaining clips into the steering wheel.
14. Route the control switch harness into the steering wheel retainer and connect the electrical connector to the control switch.
15. If the opposite side steering wheel lower cover requires replacement, repeat Steps 7-14.
16. Install the horn contact tabs and screws.
17. Tighten the horn contact tab screws.
Tighten
Tighten the horn contact tab screws to 1 Nm (9 lb in).
18. Install the horn switch and horn contact bolts. Refer to Steering Wheel Horn Switch Replacement in SI.
19. Tighten the four horn contact bolts.
Tighten
Tighten the horn contact bolts to 8 Nm (71 lb in).
20. Connect the electrical connector for the horn switch.
21. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SI.
22. Enable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling in SI.
23. Install the horn fuse.
24. Install the underhood fuse block cover.
25. Close the hood.
26. Verify proper operation of the horn and the control switches.
Parts Information
For part numbers and usage, refer to steering wheel lower cover in Group 6.512 of the appropriate parts catalog.
Warranty Information
