Yukon Denali AWD V8-6.2L (2007)
7. Install the fasteners to the reveal molding, starting from the top. Refer to Windshield Side Reveal Molding Replacement in SI.
8. Lifting the top edge of the reveal molding, grab the tail of the release lining and pull downward removing the lining.
9. Press or roll the reveal molding against the windshield ensuring adhesion of the tape to the glass.
10. Repeat steps 6-9 on the opposite side.
11. Remove tape or clean the grease pencil marks from the windshield.
12. If positioned correctly, trimming of the double sided tape should not be necessary, however inspect the reveal moldings for any tape not covered
and trim off any exposed tape.
Important
After taping the windshield reveal moldings, avoid washing the vehicle as well as excessive contact with the windshield reveal moldings for a
minimum of 72 hours.
Parts Information
3M(TM) products may be purchased through your local distributor. Information about 3M product retailers in your area may be obtained by calling
1-866-364-3577 (U.S. and Canada).
Warranty Information
