Yukon XL 2500 2WD V8-6.0L VIN N (2006)
Rear Door Hinge: Service and Repair
Rear Door Side Hinge Replacement
Rear Door Side Hinge Replacement
REMOVAL PROCEDURE
1. Remove related panel and components.
2. Remove any excess sealer surrounding the existing hinge and scribe the location of the hinge on the door (Fig. 4-40).
3. Lightly hand-sand the existing body hinge with 100 grit or finer sandpaper in order to locate the 4 welds that attach the hinge to the door.
IMPORTANT: Punch the center of the weld so that as much of the weld is removed during the drilling as possible.
4. Center punch each of the 4 weld marks on the original hinge base.
IMPORTANT: Do not drill into the door.
