Yukon XL 2500 2WD V8-6.0L VIN N (2006)
3. Connect the wire connectors.
4. Move the console forward in order to install the retaining screws.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the 2 screws (1).
Tighten the screws to 4 N.m (35 lb in).
6. Install the cupholder to the console.
7. Install the upper console bezel.
8. Install the radio amp fuse, if removed.
9. Install both front seats.
Console Replacement (W/o Console Mounting Bracket)
Console Replacement (W/o Console Mounting Bracket)
Removal Procedure
1. If equipped with a Bose(R) amplifier, remove the radio amp fuse located under the hood electrical center.
2. Remove the floor console bezel.
3. Remove the cupholder.
4. Remove the bolts (1) retaining the console to the I/P.
5. Remove the console storage bin.
6. Remove the center console end panel.
7. Remove the 4 screws retaining the upper console bracket to the lower console bracket.
The front 2 screws (1) are shown in the graphic.
