Yukon XL 2500 2WD V8-6.0L VIN N (2006)
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the 2 caliper bracket mounting bolts.
^
Tighten the brake caliper bracket mounting bolts to 175 Nm (121 ft. lbs.) (15 Series).
^
Tighten the brake caliper bracket mounting bolts to 300 Nm (221 ft. lbs.) (25 Series).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
Disc Brake Splash Shield Replacement - Front
Disc Brake Splash Shield Replacement - Front
Removal Procedure
Caution: Refer to Brake Dust in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting..
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the hub and bearing assembly. Refer to Wheel Hub, Bearing, and Seal Replacement (RWD) or Wheel Hub, Bearing, and Seal
Replacement (4WD) in Front Suspension.
4. Remove the splash shield (6) (15 Series).
