Yukon XL 2500 2WD V8-6.0L VIN N (2006)
6. Install the fuel pipe bracket to the bellhousing stud.
7. Install the fuel pipe bracket nut.
Tighten the nut to 10 N.m (89 lb in).
8. Lower the vehicle.
9. Remove the caps from the fuel rail and EVAP pipe.
10. Connect the EVAP canister purge pipe (2).
11. Connect the fuel feed line (1) to the fuel rail.
12. Install the fuel fill cap.
13. Connect the negative battery cable.
14. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF, for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
4. Inspect for fuel leaks.
