Yukon XL 2500 2WD V8-6.0L VIN N (2006)
Stabilizer Bushing: Service and Repair
Rear Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the stabilizer shaft insulator bracket mounting bolts, 15/25 series shown, 35 series similar.
3. Remove the stabilizer shaft insulators brackets.
4. Lower the stabilizer shaft and remove the stabilizer shaft insulators.
5. Inspect all of the parts for wear or damage.
Installation Procedure
1. Install the stabilizer shaft insulators to the stabilizer bar.
Important: Place the stabilizer shaft insulators on the stabilizer bar with the slits facing toward the front of the vehicle.
2. Install the stabilizer shaft insulator brackets to the rear axle., 15/25 series shown, 35 series similar.
3. Install the stabilizer shaft bracket mounting bolts.
^
Tighten the insulator bracket bolts to 33 N.m (24 lb ft).
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Lower the vehicle.
