Yukon XL 2500 2WD V8-6.0L VIN N (2006)
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the lower shock absorber nut and bolt.
^
Tighten the upper and lower shock absorber nuts to 95 Nm (70 ft. lbs.).
4. Remove the rear axle support.
5. Connect the ESC sensor, if equipped.
6. Connect the ESC electrical connector at the top of the right side shock, if equipped.
7. Connect the ESC electrical connector at the pigtail connector left side only, if equipped.
8. Remove the safety stands.
9. Lower the vehicle.
