Yukon XL 2500 2WD V8-8.1L VIN G (2004)
5. Install the housing to the bezel through the back side of the fascia. The housing snaps into the cutouts on the bezel.
6. Install the spring (1) to the housing (2) until fully seated.Ensure the sensor is held to the bumper fascia firmly.
IMPORTANT: The spring keys must be on the top and bottom of the housing.
7. Install the decoupling ring (2) to the sensor (1).
8. Insert the sensor into the housing (4) with the connector pointing toward the passenger side of the fascia. The sensor tabs snap into the cutouts on
the housing (4).
9. Connect the electrical connectors.
