Yukon XL 2500 2WD V8-8.1L VIN G (2004)
INSTALLATION PROCEDURE
1. If reusing the old sensor, Inspect both O-rings for cuts, cracks, tears or damage, replace the O-rings as needed.
2. Lubricate the CKP sensor O-rings with clean engine oil.
IMPORTANT: Ensure that the CKP sensor is fully seated against the crankshaft reluctor ring. The upper flange on the sensor MAY NOT seat
against the engine block.
3. Install the CKP sensor.
4. If reusing the old sensor, apply thread adhesive GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the threads.
IMPORTANT: The CKP sensor bolt has adhesive applied to the threads. The adhesive may have come off during removal of the bolt. Ensure that
the bolt hole is clean of any debris before installing the reinstalling bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the CKP sensor bolt.
Tighten the bolt to 12 N.m (106 lb in).
