Yukon XL 2500 4WD V8-6.0L VIN N (2006)
1. Use the J 38778 in order to remove the rear upper garnish molding.
Insert the J 38778 and work along the front edge of the trim panel from one end to the other.
2. Remove the rear upper garnish molding from the vehicle.
Installation Procedure
Install the roof rear upper garnish molding to the vehicle until it clicks into place.
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
Removal Procedure
1. Pull the molding straight out in order to release the retainers.
2. Disconnect the electrical connector.
3. Remove the windshield garnish molding.
Installation Procedure
1. Connect the electrical connector.
2. Ensure the bottom of the molding is seated in the slots on the I/P.
3. Align the molding retainers to the slots.
4. Press the moldings straight in till fully seated.
Trim Panel Replacement - Hinge Pillar
