Yukon XL 2500 4WD V8-6.0L VIN N (2006)
Rear Axle Shaft Seal Replacement - Outer
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Remove the axle shaft.
4. Remove the axle shaft seal.
Installation Procedure
1. Install the axle shaft seal.
2. Install the axle shaft.
3. Install the tire and wheel assembly.
4. Lower the vehicle.
Rear Axle Shaft Seal Replacement - Inner
Rear Axle Shaft Seal Replacement - Inner
^
Tools Required
-
J 33049 Camshaft Bearing Service Set
-
J 45177 Differential Seal Installer - Inner
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Remove the axle shafts.
4. Remove the differential assembly.
5. Install the smallest expanding driver (3) and the small driving washer (1) onto the expander assembly (2).
