Yukon XL 2500 4WD V8-6.0L VIN U (2005)
1. Install the left engine mount to the engine.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount bolts to the engine.
^
Tighten the engine mount bolts to 50 Nm (37 ft. lbs.).
3. Lower the engine.
4. Remove the adjustable jack stands.
5. For vehicles with 4WD, install the front propeller shaft.
6. Install the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).
^
Tighten the engine mount-to-engine mount bracket bolts to 65 Nm (48 ft. lbs.).
7. Install the wheelhouse panel from the vehicle.
8. Install the tire and wheel.
9. Lower the vehicle.
Engine Mount Replacement - Right
Engine Mount Replacement - Right
Removal Procedure
1. Remove the exhaust manifold.
2. Remove the engine mount-to-engine mount bracket bolts.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and wheel.