Yukon XL 2500 4WD V8-6.0L VIN U (2005)
Ride Height Sensor: Service and Repair
Rear Position Sensor Replacement - Electronic Suspension - Left
Rear Position Sensor Replacement - Electronic Suspension - Left (25 Series)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Remove the bolts.
5. Remove the position sensor from the vehicle.
6. Disconnect the sensor link from the ball stud.
Installation Procedure
1. Install the position sensor on the vehicle.
2. Install the bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Connect the sensor link to the ball stud.
