Yukon XL 2500 4WD V8-6.0L VIN U (2005)
Notice: Refer to Fastener Notice in Service Precautions.
13. Install 2 NEW screws (1) to the casting.
^
Tighten the screws to 2 Nm (18 inch lbs.).
14. Install 2 NEW longer screws (2) to the motor cover.
^
Tighten the screws to 3 Nm (26 inch lbs.).
15. Install the encoder motor.
Transfer Case Speed Sensor Replacement - Front
Transfer Case Speed Sensor Replacement - Front
Removal Procedure
1. Remove the transfer case shield, if equipped.
2. Disconnect the front speed sensor electrical connector (5).
3. Remove the front speed sensor.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the front speed sensor.
^
Tighten the speed sensor to 15 Nm (11 ft. lbs.).