Yukon XL 4WD V8-5.3L (2011)
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Working through the wheelhouse opening, install the engine mount to engine bolts (1) and tighten to 50 Nm (37 lb ft).
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block.
5. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side See: Body and Frame/Fender/Front Fender/Front
Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Left Side.
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1) and tighten to 65 Nm (48 lb ft) starting with the middle bolt then either side bolt.
8. Install the generator bracket. Refer to Generator Bracket Replacement See: Starting and Charging/Charging System/Alternator/Service and
Repair/Generator Bracket Replacement.
9. If the vehicle is equipped with 4WD, install the front drive axle. Refer to Differential Carrier Assembly Replacement.
10. Lower the vehicle.
11. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement See: Tune-up and Engine Performance Checks/Air
Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Cleaner Resonator Outlet Duct Replacement.
