Yukon XL 4WD V8-5.3L (2011)
Wheels: Service and Repair
Aluminum Wheel Porosity Repair
Aluminum Wheel Porosity Repair
1. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation See: Service and Repair.
2. Inflate the tire to the manufactures specified pressure as stated on the tire.
3. Submerge the tire/wheel into a water bath in order to locate the leak.
4. Inscribe a mark on the wheel in order to indicate the leak areas.
5. Inscribe a mark on the tire at the valve stem in order to indicate the orientation of the tire to the wheel.
6. Remove the tire from the wheel. Refer to Tire Dismounting and Mounting See: Tires/Service and Repair/Removal and Replacement.
Note: Do not damage the exterior surface of the wheel.
7. Use number 80 grit sandpaper to scuff the inside of the rim surface at the leak area.
8. Use general purpose cleaner to clean the leak area.
9. Apply 3 mm (0.12 in) thick layer of adhesive/sealant to the leak area. Refer to Adhesives, Fluids, Lubricants, and Sealers See:
Suspension/Specifications/Fluid Type Specifications.
10. Allow for the adhesive/sealant to dry.
11. Align the inscribed mark on the tire with the valve stem on the wheel.
12. Install the tire to the wheel. Refer to Tire Dismounting and Mounting See: Tires/Service and Repair/Removal and Replacement.
13. Pressurize the tire to 276 kPa (40 psi).
14. Submerge the tire/wheel into a water bath in order ensure the leak is sealed.
15. Inflate the tire to the specified pressure as stated on the tire placard.
16. Balance the tire and wheel. Refer to Tire and Wheel Assembly Balancing - Off Vehicle See: Body and Frame/Testing and Inspection/Vibration
Diagnosis and Correction/Repair Instructions/Tire and Wheel Assembly Balancing - Off Vehicle.
17. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation See: Service and Repair.
