Yukon XL 4WD V8-5.3L (2011)
Shift Cable: Service and Repair
6L45/6L50/6L80/6L90 - Automatic Transmission
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
Warning
The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two metal couplings from one
another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings occurs. When servicing the transaxle
remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range selector cable bracket. If either section of the cable
needs to be replaced, replace both of the cable sections. Loss of connection integrity of the two metal couplings can cause loss of transaxle shift control
which could result in personal injury.
1. Position the steering column shift lever to the park position.
2. Remove the instrument panel knee bolster. Refer to Knee Bolster Replacement .
3. Remove the driver seat. Refer to Front Seat Replacement - Bucket .
4. Pull back the carpet and insulation around the driver area.
5. Remove the retainer securing the cable to the steering column.
