Yukon XL 4WD V8-5.3L (2011)
7. Install the manual shift detent spring (5).
8. Install the manual shift detent spring bolt (4) and tighten to 11 Nm (97 lb in)..
9. Connect the control wiring harness to the control solenoid valve body (3).
10. Connect the output shaft speed sensor connector.
11. Connect the manual shift shaft position switch.
12. Install the control wiring harness connector (1) in the wire harness retainer.
13. Install the control wiring harness to the wire harness retainer (2).
14. Install the transmission electrical connector passage sleeve. Refer to Automatic Transmission Electrical Connector Passage Sleeve Replacement
See: Automatic Transmission Electrical Connector Passage Sleeve Replacement.
15. Connect the transmission 16 Way connector.
16. Connect the transmission 24 Way connector.
17. Install the transmission fluid filter and auxiliary fluid pump filter. Refer to Automatic Transmission Fluid Filter and Auxiliary Fluid Pump Filter
Replacement See: Fluid Filter - A/T/Service and Repair/2ML70 - Automatic Transmission.
Automatic Transmission Electrical Connector Passage Sleeve Replacement
