Yukon XL 4WD V8-5.3L (2011)
Note: If the wheel hub assembly does not fully seat itself onto the axle shaft spindle and is removed, the wheel hub seal must be replaced.
12. Install the wheel hub to the axle housing.
13. Using the J 2222-C - wrench , install the adjusting nut to the hub.
14. Adjust the wheel bearings. Refer to Wheel Bearing Adjustment See: Differential Assembly/Service and Repair/Procedures/Rear Drive
Axle/Wheel Bearing Adjustment.
15. Install the axle shaft. Refer to Rear Axle Shaft and/or Gasket Replacement See: Rear Axle Shaft and/or Gasket Replacement.
16. Install the brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
17. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
18. Inspect and add axle lubricant to the axle housing, if necessary. Refer to Rear Axle Lubricant Level Inspection .
19. Lower the vehicle.
