Yukon XL 4WD V8-6.0L (2007)
If there is damage to any of the wires of the seat harness then repair as necessary. If the damage is on the seat belt buckle pigtail, replace the buckle. In
order to prevent any future wiring issues involving the seat belt tension sensor circuits, the wiring should be rerouted as pictured (refer to diagrams).
The seat belt tension sensor circuit has been rerouted so as to run underneath the black conduit.
Once you have rerouted the circuit, tape around the plastic channel in order to hold the wiring in the channel. Refer to diagram.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer