Accord L4-1751cc 1800 EK1 (1982)
Buss Bar Installation Procedure
8.
Remove the tape from the weatherstrip. Pull the weatherstrip back and fit the edge of the mask under it, then press the mask into position so it
covers the buss bars.
Buss Bar Installation Procedure
9.
Check the fit from the outside of the glass; the mask should completely cover the new buss bar and overlap its inboard edge by 1 mm. If it
doesn't, reposition the mask and check it again.
10.
Gently scrape the excess silicone off the glass with a putty knife, then wipe off the remaining film with a clean rag.
