Accord L4-1829cc 1.8L SOHC ES, ET FI (1985)
6. Loosen the right sealing band and slide it to the left.
7. Remove the screw in the outside air door diaphragm (leave the diaphragm attached to the air door arm) and the blower mount bolts, then remove
the blower.
8. Remove the left sealing band and disconnect the wire.
9. Remove the three bolts and remove the evaporator.
10. Install the evaporator in the reverse order of removal.
-
If a new evaporator, add 30 cc of refrigerant oil to it before charging.
-
Remember to install the left sealing band and tighten the right band securely to prevent air leaking past the joint.
-
Apply sealant to the inside and outside mating surfaces of the receiver line and suction hose grommets.
-
Charge the system.
-
Test performance.