Accord L4-1829cc 1.8L SOHC ES, ET FI (1985)
4.
Remove both steering gearbox mount brackets, then pull the gearbox down and remove and discard the left mount bushing.
5.
Make sure the mount bracket and the mount areas on the gearbox and the frame are clean and dry. Then slip the new bushing on with its split side
toward the rear of the car.
6.
Reinstall the gearbox and torque its mount bolts to 22 Nm (16 ft. lb.).
7.
Reinstall the control unit shield.
8.
Reinstall the center beam and torque its bofts to 50 Nm (36 lb. ft.).
9.
Reconnect the steering shaft connector (line up the top edge with the mark you made on the splines) and torque its bolts to 30 Nm (22 lb. ft.).
10.
Reinstall the boot.
11.
Road test the car. If the steering wheel is still turned toward one side while you're driving straight ahead, adjust both tie rods in the other direction
to bring it back "on center."
NOTE:
One full turn of the tie rods will change steering position by 10~. If, for example, the wheel is off 10~ to the right, adjust both tie rods to
the left one turn.
PARTS INFORMATION
Power steering gearbox cushion A
H/C 1983204
P/N 53435-SB0-951
WARRANTY COVERAGE
Normal warranty applies.
WARRANTY CLAIM INFORMATION
Operation number:
513105
Flat Rate Time:
0.8 hour (includes road test) Failed part H/C: 114052
Defect code:
074
Contention code:
B04