Accord L4-1955cc 2.0L SOHC 2-bbl (1986)
8.
Spray all parts of the fuel filler pipe assembly with 3M Rust Fighter I. Coat it completely, with a heavier coating in the shaded areas shown.
9.
Allow to dry for five minutes. Apply two more coats of Rust Fighter I, allowing five minutes drying time after each coat.
10.
Inspect the fuel filler pipe assembly for any areas that are not coated well. Respray any areas you find.
11.
Apply a coat of Noxrust 124B to the filler pipe assembly.
12.
Install the two fuel filler pipe mounting bolts and tighten the three mounting nuts. Allow the Noxrust 124B to dry for 20 minutes.
13.
Go to Completion Procedure. New Fuel Filler Pipe Installation
If it is necessary to replace the fuel filler pipe, install the tube kit to the pipe assembly before installing the assembly in the car.
1.
Spray the inside of the flexible tubing from the kit with silicone spray.
2.
Spray the end of the 6.3 mm metal vent tube on the pipe assembly with silicone spray.
