Accord L4-2.2L SOHC VTEC (1994)
5. Install the pin in the cam.
6. Apply recommended grease to the new O-ring and install it on the sleeve piston.
7. Install the sleeve piston so the hole in the bottom of the piston is aligned with the pin in the cam and two pins on the piston are aligned with the
holes in the caliper.
8. Coat a new cup with recommended grease, and install it with its groove facing the bearing A side of the adjusting bolt.
9. Fit the bearing A, spacer, adjusting spring B and spring cover on the adjusting bolt, and install them in the caliper cylinder.
10. Install the special tool on the spring cover and turn the shaft until the locknut contacts the plate
11. Check that the flared end of the spring cover is below the circlip groove.
