Accord L4-2.2L SOHC VTEC (1994)
ABS Accumulator: Service and Repair
Removal and Installation
Fig. 94 Accumulator Replacement
Refer to Fig. 94 when replacing accumulator.
WARNING: The accumulator contains high pressure nitrogen gas. Do not puncture, expose to flame, weld, drop or apply impact to the
accumulator, or attempt to remove the accumulator from the modulator unit. The modulator unit may explode and severe personal injury
may result.
1. Drain the high-pressure brake fluid from the modulator unit.
2. secure the modulator unit in a vise so that the relief plug points straight up.
3. Loosen the relief plug three and a half turns slowly and wait for three minutes for all pressure to escape.
4. remove the accumulator from the modulator unit.
5. remove the relief plug completely and dispose of the accumulator.
