Accord L4-2.2L SOHC VTEC (1994)
Flat rate time:
0.8 hour
Failed part:
P/N 57110-ST7-003
H/C 4251609
Defect code:
060
Contention code:
B06
Template ID:
94-029A NEW
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.
Corrective Action
Replace the accumulator and 0-ring with the kit listed under PARTS INFORMATION.
1.
Attach a hose to the bleeder screw and relieve the system pressure. Refer to service manual page 19-128 for the proper procedure.
2.
Disconnect the 14P and 2P connectors from the modulator.
3.
Remove the six brake lines from the modulator.
4.
Remove the wire harness clip from the modulator bracket.
5.
Remove the three modulator mounting nuts. Remove the modulator from the car.
6.
Remove the two mounting bolts and remove the accumulator from the modulator.
NOTE:
Do not place the modulator in a bench vise. You could damage the fittings.
7.
Do not release the nitrogen from the accumulator at this time. The accumulator should be stored, fully pressurized, for 30 days for warranty parts
call-in. If it is not called in within 30 days, the accumulator should then be depressurized and discarded.
8.
Install the 0-ring on the new accumulator (see PARTS INFORMATION).
9.
Install the accumulator on the modulator. Tighten the mounting bolts to 9.8 N.m (1.0 kg-m, 7 lb-ft).
10.
Install the modulator in the car. Tighten the mounting nuts to 22 N.m (2.2 kg-m, 16 lb-ft).
11.
Reconnect the brake lines, wire harness clip, and electrical connectors. Tighten the brake lines to 19 Nm (1.9 kg-m, 14 lb-ft).
12.
Fill the modulator and brake reservoirs with Honda brake fluid.
