Accord L4-2.2L SOHC VTEC (1994)
13.
Bleed the brake system. Refer to service manual page 19-6.
14.
Bleed the ABS modulator. Refer to service manual page 19-129.
Modulator Final Bleeding Procedure
15.
Connect a piece of 3/8 inch O.D. hose to the pressure side of a hand-held vacuum pump.
16.
Remove the filler cap from the modulator reservoir. Leave the plastic insert in the modulator opening.
17.
Start the engine. Hold the vacuum pump hose against the modulator opening insert. To pressurize the reservoir, pump the vacuum pump until you
feel resistance (1 to 3 strokes).
18.
While keeping the reservoir pressurized, have an assistant turn off the engine and then slowly open the modulator bleeder.
19.
Close the bleeder when brake fluid stops running into the tube.
20.
Repeat steps 18 through 20 five times to purge the air from the modulator.
21.
Clear any codes in the ABS control unit memory by removing the ABS B2 fuse in the under-hood ABS fuse box for three seconds.
