Accord L4-2.2L SOHC VTEC (1994)
Shift Indicator: Testing and Inspection
CAUTION:
-
GAll SRS electrical wiring harnesses are covered with yellow outer insulation.
-
Before disconnecting the SRS wire harness, install the short connector on the airbag.
-
Replace the entire effected SRS harness assembly if it has an open circuit or damaged wiring:
Remove the gauge assembly from the dashboard and disconnect the 7-P, 18-P and 22-P connectors from the gauge assembly. Make the following
input tests at the connector terminals. If all tests prove OK, yet the indicator still fails to work, replace the main print panel, speedometer, tachometer
and odo/trip meter.
NOTE: Several different wires have the same color. They have been given a number suffix to distinguish them (for example GRN1 and GRN2 are not
the same).
