Accord L4-2.2L SOHC VTEC (1994)
Data Link Connector and SCS Connector (with Shorting Service Connector installed)
Timing Marks
CAUTION: Do not short any of the pins on the 3 pin Data Link Connector together or to ground.
17. Install a shorting connector at the 2 pin Service Check Connector and set the timing with a timing light to 15° ±2° BTDC @ 700 ±50 rpm (red
line on crank pulley). Remove the shorting connector from the Service Check Connector.
18. After adjusting, torque the hold-down bolts, then install the cap on the bolt.
Torque: 18 Nm (13 ft.lbs)