Accord L4-2.2L SOHC VTEC (1994)
3.
Raise the window. Loosen the lower mounting bolts in the window regulator. Then move the regulator forward so the bolts are at the front of their
mounting slots. Retighten the bolts to 10 Nm (1.0 kg-m, 7 lb-ft).
4.
Lower the window a few inches. Put two pieces of masking tape on the outside of the glass in the locations shown.
5.
Raise the window fully. Using the edge of the run channel as a guide, draw a line on each piece of masking tape.
6.
Lower the window partially. Measure the distance from the line on each piece of tape to the edge of the glass.
^
If both measurements are 1.5 mm or more, the adjustment is OK; go to step 9.
^
If either measurement is less than 1.5 mm, go to step 7.
