Accord L4-2.4L (2005)
13. Measure and note the prepare weight (M1) again with a weight scale.
14. Place the weight on the front passenger's seat.
15. Drive the vehicle, accelerate to 20 mph (36 km/hr), then stop on level ground.
16. From the tester's Main Menu, select SRS, then seat weight sensor, then Misc Test, then Inspection. Select "SEAT OUTPUT CHK."in the HDS
Inspection Menu. The weight (T1) of the front passenger's seat is recorded by the HDS.
17. Calculate the variance between the weight measured by the weight scale and the HDS with the formula below.
Variance = (T1) - (M1) < ±18.6 lbs (3.9 kg)
T1: Weight measured by the HDS with the weight on the seat
M1: Weight measured by the weight scale.
-
If the variance is 18.6 lbs (±3.9 kg) or less, calibration is complete. Go to step 18.
-
If the variance is more than 18.6 lbs (13.9 kg), replace the front passenger's weight sensors (if they were not replaced before this step), and
repeat this procedure from the beginning.
18. Turn the ignition switch OFF, and disconnect the tester from the DLC.
