Accord L4-2.4L (2005)
24. Install the new cover seal (A) all the way around in the steering joint cover B. Make sure there are no wrinkles in the seal, then install the steering
joint cover B.
25. Center the steering rack within its stroke.
26. Position the steering column joint (A) so the bolt (B) opposite to the notch (C) is within the range shown.
27. With the rack in the straight ahead driving position, cut the wire (D) and slip the lower end of the steering joint on to pinion shaft (E).
28. Align the bolt hole (A) on the steering joint with the groove (B) around the pinion shaft, and loosely install the joint bolt (C). Make sure the joint
bolt is securely in the groove in the pinion shaft. Pull on the steering joint to make sure the steering joint is fully seated.
29. Tighten the steering joint bolt to the specified torque.
